Search results

...rom the sale of their self designed and manufactured inexpensive models of revolvers. Not much is known about Martin Bye, as there is very little documented in ...safety”) and the automatic ejection of cartridges upon breaking open the revolvers (“automatic”).

...rand'', along with ''Textbook of Pistols and Revolvers'' and ''Pistols and Revolvers and Their Use''s. He was also a pioneer in the forensic identification of f * Julian S. Hatcher, ''Pistols and Revolvers and Their Use'', Marshallton, Del., Small-Arms Technical Pub. Co., 1927 [Ri

...ld be to use a manually cycled [[firearm action]], such as a [[revolver]]. Revolvers are viable option for shooters who have difficulty with semiautomatic desig

*[[Beretta|Beretta Revolvers]] *[[Colt's Manufacturing Company|Colt Revolvers]]

...t for wielding one-handed and for [[self-defense]], and that differ from [[revolvers]] and other singled handed weapons through their [[Semi-automatic pistol|se

... the then-new, more powerful 9 mm round. Field experience with .38 caliber revolvers in the Philippines and ballistic tests would result in a requirement for st

...xt decade would see a similar pace, including the adoption of several more revolvers and an intensive search for a self-loading pistol that would culminate in o ...with the .38 Long Colt led to the army shipping new single action .45 Colt revolvers to the Philippines in 1902. It also prompted the then-Chief of Ordnance, Ge

...re bullets at Turks. While ahead of its time, foreshadowing the designs of revolvers, it was not adopted or produced. ... pistols did away with needing multiple hammers but used multiple barrels. Revolvers further reduced this to only needing a pre-prepared magazine using the same

...is sign on State Street, New Haven, to start manufacturing his own line of revolvers and [[derringer]]s.

...nds are chambered by hand (e.g. single shots, double rifles, drillings and revolvers) and not by a mechanism.

...itary-issue .45 ACP ammunition.<ref>Josserand MH, Stevenson JA: ''Pistols, revolvers, and ammunition''. New York, Bonanza Books (a division of Crown Publishers) [[category:revolvers]]

... with the NFA. Their regulation to that effect is found at 27 CFR sec. 179.22. The regulation is apparently based upon 26 U.S.C. sec. 7606: | 3310.4 || Report of Multiple Sale or Other Disposition of Pistols and Revolvers

....32]] calibre. The handgun categories include approximately half of the [[revolvers]] and [[pistols]] owned in [[Canada]]. There are specific provisions liste

== Mini revolvers == ...ocket revolvers, the major difference being the size and the fact the mini-revolvers are made completely of stainless steel.<ref>http://naaminis.com/index01.htm

...Beach, San Diego, California, where citizens carrying unloaded pistols and revolvers were subjected to Section 12031(e) inspections of their firearms on demand

<option>If householders were required by law to own and know how to use [[revolvers]], burglary would cease. It is an act of good citizenship to make crime dan

...vided far more velocity and energy in the rifles, but were not safe in the revolvers due to the higher pressures they generated. These loads were eventually dr ...can use +P ammunition; for example, many aluminum alloy framed .38 Special revolvers should not regularly be used with +P ammunition, for while the cylinder is

===Nitrated cartridges for percussion revolvers=== ...as they load from the front of the cylinder. Typical paper cartridges for revolvers differ from the robust percussion rifle cartridges, in that the cartridge i